Macro Toolworks Products Discussion Forums :: Macros & Solutions
Board Index Latest Posts Welcome Guest   
 Subject :Macro repeats the click on his own...... 26-01-2011 02:18:58 
ronmar_lasco@yahoo.com
Joined: 26-01-2011 00:50:37
Posts: 8
Location: 
I'm trying out the software but Im experiencing a problem.

here's the macro:
Untitled-1.png

after clicking the 3 areas stated in succession, the macro will continuously
cycle from the 1st click and 2nd click. I added "exitmacro" , but it will still cycle
once after the 3rd click. Is this a bug or am I doing it wrong?

I'm sure my recording is correct and I don't cycle it.
IP Logged
Last Edited On: 26-01-2011 02:21:46 By ronmar_lasco@yahoo.com for the Reason
 Subject :Re:Macro repeats the click on his own...... 02-02-2011 20:52:45 
murraymd
Joined: 17-05-2010 03:31:48
Posts: 9
Location: 
In the screenshot you posted there's another tab marked "Macro Text". If you click on that tab then do a screenshot or cut-and-paste the code you see there it would be easier to diagnose your problem. Thanks,

Dave
IP Logged
Malcolm D. Murray
 Subject :Re:Macro repeats the click on his own...... 14-02-2011 09:39:06 
petr
Joined: 15-10-2009 11:48:52
Posts: 152
Location: 
Hello,

I have some ideas what could cause this:

1) It is possible to set macro to repeat several times (in Macro Properties). Make sure number of repeats is set to 1.

2) It is possible that the macro is triggered again and again so that it looks like certain steps are repeating while whole the macro is run again and again....

Petr
IP Logged
Page # 


Powered by ccBoard


Login and share your experience - send messages to forums and add comments to samples, commands and other resources.



Account is free of charge, easy to setup.