Macro Toolworks Products Discussion Forums :: Suggestions & Bug Reports
Welcome Guest   
 Subject :error when using comment.. 07-10-2011 00:56:35 
hugblue@hotmail.com
Joined: 13-10-2010 01:09:07
Posts: 100
Location: sweden
one day i had typed around 1500 lines of code.
and to remember the different sections. i use comments.

normally i use a comment as a seperator like this :
but that day i would do it with : **************************

later that day, i needed to copy around 75% of the code. and the computer
constantly keept freezing/tilt. and after having looked the code through.

i found out that the comment line. didnt hold : *************************
but had somehow got full of code from the program.

i tried to delete the comment line. but is not possible.
so i had to rewrite a big portion of the code.

i cannot right now give an example of the code.
because it contain information that i cannot share.
IP Logged
 Subject :Re:error when using comment.. 24-03-2012 14:02:19 
hugblue@hotmail.com
Joined: 13-10-2010 01:09:07
Posts: 100
Location: sweden
after some time fiddling around. i found out where the error could be.

when i copy and paste a code to a text document. sometimes it fills all the code with returns. everywhere. and when i paste the code back to toolworks. it really can f... everything up. almost lost 4000-5000 lines. and took around 4 hours to make everything run normal again.

so dont paste to documents. if so. remember always to make a backup first.

so now i run toolworks on a ram drive. that is backed up every 15 min to another drive. i think we learn by our errors. smiling. i did.
IP Logged
Page # 


Powered by ccBoard


Login and share your experience - send messages to forums and add comments to samples, commands and other resources.



Account is free of charge, easy to setup.